JTAG HS2 Programming Cable

The Joint Test Action Group (JTAG)-HS2 programming cable is a high-speed programming solution for Xilinx field-programmable gate arrays (FPGAs). The cable is fully compatible will all Xilinx tools and can be seamlessly driven from iMPACT, Chipscope, and EDK. The HS2 attaches to target boards using Digilents 6-pin, 100-mil spaced programming header or Xilinxs 2x7, 2mm connector and the included adaptor.

The PC powers the JTAG-HS2 through the USB port and will recognize it as a Digilent programming cable when connected to a PC, even if the cable is not attached to the target board. The HS2 has a separate Vdd pin to supply the JTAG signal buffers. The high speed 24mA three-state buffers allow target boards to drive the HS2 with signal voltages from 1.8V to 5V and bus speeds of up to 30MBit/sec. (See figure 1) To function correctly the HS2s Vdd pin must be tied to the same voltage supply that drives the JTAG port on the FPGA.

The JTAG bus can be shared with other devices as systems hold JTAG signals at high-impedance except when actively driven during programming. The HS2 comes included with a standard Type-A to Micro-USB cable that attaches to the end of the module opposite the system board connector. The system board connector should hold the small and light HS2 firmly in place.

Need help choosing a board? Let us help you with a Programming Solutions Comparison table!

Features

Analog Devices ADP123AUJZ Linear Regulator
Small, complete, all-in-one JTAG programming solution for Xilinx FPGAs
Compatible with all Xilinx tools
Compatible with IEEE 1149.7-2009 Class T0 - Class T4 (includes 2-Wire JTAG)
Separate Vref drives JTAG/SPI signal voltages; Vref can be any voltage between 1.8V and 5V.
High-Speed USB2 port that can drive JTAG/SPI bus at up to 30Mbit/sec
JTAG/SPI frequency settable by user
Uses micro-AB USB2 connector
SPI programming solution (modes 0 and 2 up to 30Mbit/sec, modes 1 and 3 up to 2Mbit/sec)
Fully supported by Digilent's Adept software and Adept SDK, allowing custom JTAG/SPI applications to be created

Scope of Delivery

USB cable (type-A USB plug, type-AB micro-USB plug)
JTAG HS2 Programmer
6-pin to 2x7-pin Adapter

References

Manufacturer: Digilent Inc.
Manufacturer's article name: JTAG HS2 Programming Cable
Manufacturer's article number: 410-249

Resources

Other Digilent products are available on request.

ID de l’art.	100263
État
ID de l'ancien article	2038
Modèle	410-249
Fabricant	Digilent Inc.
Pays de fabrication	Taiwan
Contenu	1 pièce
Poids	54 g
Poids net	54 g